HP Insight Control Server Provisioning 7.2 Update 2 Installation Guide

Figure 7 Appliance Networking screen

The next step is to configure the Appliance IP:

• “Configure Appliance IP” (page 21)

And then you configure the Deployment IP on the same or a different network:

• “Configure Deployment IP on the same network” (page 23)

• “Configure Deployment IP on a different network” (page 24)

• “Check for errors in first time setup” (page 25)

Configure Appliance IP

To begin configuring the Appliance IP, select the 1 Appliance network interface in the Appliance

Networking screen. A set of fields is displayed for you to configure the Appliance IP (as shown

below).

NOTE: If your appliance received a DHCP address from a server on the network, some of the

networking values may already be populated. Any DHCP assigned address must be replaced by

a permanent static IP address. DHCP will not be enabled once the appliance is set up.