HP Insight Control Server Provisioning 7.2 Online Help

Table 58 IPv4 input fields on the Appliance Networking screen (continued)
NOTE: You must turn off the appliance DHCP server to change this value.
NOTE: If you are using Matrix Operating Environment and you change this
IP address, you must restore communication between IC server provisioning
and Matrix OE as described in “Restore communication with Matrix OE if I
changed the Deployment IP address” (page 33).
Default value: None
Required: Yes
Subnet mask or
CIDR
Description: This is the IPv4 mask representing the bits reserved for network identification
(for example, 255.255.255.0) , or the Classless Internet Domain Routing (CIDR)
mask representing the number of bits reserved for network identification. Valid
CIDR values are 1 to 30, inclusive. If you have DHCP running on your network,
this field will initially show the value assigned by DHCP.
Default value: None
Required: This field is required if you are specifying a gateway.
Gateway address Description: You may edit this field only if you selected Manual address assignment, in which
case it is not required but HP strongly suggests configuring it to ensure access
to the appliance. This is the IP address for the network interface on your router.
If you have DHCP running on your network, this field will initially show the value
assigned by DHCP.
Default value: None
Required: No, but HP strongly suggests configuring it to ensure access to the appliance.
10.8.3 Editing appliance networking DNS information
Table 59 DNS input fields on the Appliance Networking screen
Preferred DNS
server
Description: The IP address of your preferred DNS server.
Default value: If you selected DHCP address assignment, the default value will be the one
discovered by DHCP.
Required: No
Alternate DNS
server
Description: The IP address of your alternate DNS server.
Default value: If you selected DHCP address assignment, the default value will be the one
discovered by DHCP.
Required: No
10.8.4 Appliance time and place information
Table 60 Time and place fields on the Appliance Networking screen
This is the current date and time for the appliance. This is read only.Current date and
time
The time zone for the appliance is always UTC. This is read only.Time zone
This is the current setting for the locale. This is read onlyDefault language /
locale
86 Settings