HP Insight control for Linux 6.2 Installation Guide

Gathering configuration data...
For more information about how to answer a configuration question,
enter a question mark(?).
Press enter to continue. Enter
Would you like to use an existing Oracle database as the HP SIM database? (y/n) [n]
1
Device IP
------- -----------------------
eth0 192.0.2.10
Enter which network device to use for the CMS management interface: [eth0]
2
Enter TCP Port for the Insight Control for Linux repository web server: [60000]
3
MANAGEMENT PROCESSOR CREDENTIALS
IMPORTANT - The user name and password selected here will be added to any management
processor that is discovered through the bare metal discovery process.
If that user name already exists, the existing password will be overwritten by the
password specified here.
Enter ? for complete details and configuration alternatives.
Enter the default management processor user name: [Administrator]
Enter the default management processor password:
4
Re-enter to verify:
Enter the IC-Linux collection name: [icelx]
5
Enter the HP SIM CMS user name: [root]
6
Enter the HP SIM CMS password:
Re-enter to verify:
Do you want the CMS to automatically export /hptc_cluster to the management
hub nodes? (y/n) [n]
7
Do you want the CMS to be a DHCP server? (y/n) [n]
8
1
Table 5-1 (page 40) lists the information you are required to supply for a pre-existing
Oracle database. If you answer yes to this question, the HP Insight Control for
Linux installation process collects all of the information pertaining to the location
of and credentials for the Oracle database and ensures that Systems Insight Manager
is installed appropriately for use with the Oracle database.
2
Select the device name that corresponds to the CMS management interface. The
CMS management interface is the Ethernet adapter that is used for communication
between the CMS and the managed systems.
3
Enter the number of the TCP port that you want to use for the Insight Control for
Linux repository web server; the default is port 60000. If another service is already
using that port, you are prompted for another entry.
4
Do not use the following characters in the MP password: dollar sign ($), at sign
(@), single left quote (`), percent sign (%), and double quote (“).
The default setting on an iLO MP accepts passwords equal to or greater than eight
characters in length. If you want to use a password that contains less than eight
characters, you must change the setting on the iLO. In addition, there are restrictions
on LO100 passwords: any characters over 16 characters are ignored.
6
You must enter root as the Systems Insight Manager user name, and you must
enter the root password.
5
After you have successfully run the install.sh script, you must always use the
same collection name if you ever rerun the script. In this release, HP does not
support changing the collection name after the install.sh script completes.
7
See Table 5-1 (page 40) for the reasons for exporting the /hptc_cluster file
system to the management hub servers.
8
If you answer y to configure the CMS as a DHCP server, you are prompted to
supply the DHCP configuration information listed in Table 5-2 (page 43).
If you answer n to use a pre-existing DHCP server, see Chapter 4 (page 29), which
describes DHCP configuration requirements for Insight Control for Linux.
46 Installing Systems Insight Manager and Insight Control for Linux