Ignite-UX Release Notes HP-UX 11iv1, HP-UX 11iv2 and HP-UX 11iv3 (762792-001, March 2014)

• QXCR1001144624—The 'ignite client list' command correctly displays macaddress
information for all the client NICs.
• QXCR1001153339—Ignite-UX uses the new -B option of the setboot command to avoid
unnecessary generation of IPMI calls.
• QXCR1001154910—The print_manifest command is changed to display disk sizes
greater than 4TB.
• QXCR1001155333—Ignite-UX provides support to automatically detect the pax block size.
• QXCR1001164448—The list_expander command is updated to handle the symlinks
efficiently and to check what is to be included in the archive.
• QXCR1001166847—For VxVM, the name of the file system does not necessarily have to
end with 'vol'.
• QXCR1001173668—The make_*_recovery command is enabled to support archive and
recovery of systems in agile-DSF mode. This feature is currently limited to systems that do
not use sasd driver based disks.
Notes related to known problems with this release:
There are no new known problems.
Version C.7.13.259 (September 2011 - web release only)
The C.7.13.259 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 11 HP-UX release/architecture combinations supported on Ignite-UX version C.7.13.259
HP Integrity systemsHP 9000 systemsHP-UX release
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
After downloading from the web, this version can be installed on any server running on any one
of the above HP-UX releases.
Ignite-UX version C.7.13.259 contains the following new feature:
Fix for the following Change Request:
• QXCR1001120228—Following the replacement of Vx* 5.0 bits by Vx* 5.0.1 in the Operating
Environment of September 2011 release of HP-UX 11i v3, Ignite-UX Install Environment has
been completely updated with the Vx* 5.0.1 drivers and command binaries.
Notes related to known problems with this release:
There are no new known problems.
Version C.7.13.259 (September 2011 - web release only) 17