Ignite-UX Release Notes HP-UX 11iv1, HP-UX 11iv2, and HP-UX 11iv3 (5900-3360, November 2013)

• QXCR1001144624. The 'ignite client list' command correctly displays macaddress

information for all the client NICs.

• QXCR1001153339. Ignite-UX uses the new -B option of the setboot command to avoid

unnecessary generation of IPMI calls.

• QXCR1001154910. The print_manifest command is changed to display disk sizes

greater than 4TB.

• QXCR1001155333. Ignite-UX provides support to automatically detect the pax block size.

• QXCR1001164448. The list_expander command is updated to handle the symlinks

efficiently and to check what is to be included in the archive.

• QXCR1001166847. For VxVM, the name of the file system does not necessarily have to end

with 'vol'.

• QXCR1001173668. The make_*_recovery command is enabled to support archive and

recovery of systems in agile-DSF mode. This feature is currently limited to systems that do

not use sasd driver based disks.

Notes related to known problems with this release:

There are no new known problems.

Version C.7.13.259 (September 2011 - Web release only)

The C.7.13.259 release of Ignite-UX supports the following HP-UX release/architecture combinations:

Table 10 HP-UX release/architecture combinations supported on Ignite-UX version C.7.13.259

HP Integrity systemsHP 9000 systemsHP-UX release

NoYesB.11.11

YesYesB.11.23

YesYesB.11.31

After downloading from the Web, this version can be installed on any server running on any one

of the above HP-UX releases.

Ignite-UX version C.7.13.259 contains the following new feature:

Fix for the following Change Request:

• QXCR1001120228. Following the replacement of Vx* 5.0 bits by Vx* 5.0.1 in the Operating

Environment of September 2011 release of HP-UX 11i v3, Ignite-UX Install Environment has

been completely updated with the Vx* 5.0.1 drivers and command binaries.

Notes related to known problems with this release:

There are no new known problems.

Version C.7.13.240 (September 2011)

The C.7.13.240 release of Ignite-UX supports the following HP-UX release/architecture combinations: