Ignite-UX Release Notes HP-UX 11iv1, HP-UX 11iv2, and HP-UX 11iv3 (5900-3360, November 2013)

Version C.7.17.361 (October 2013 – This version is suspended and
unsupported.)
IMPORTANT: The C.7.17.361 release of Ignite-UX is suspended and is unsupported to use due
to packaging issues. See HP customer advisory c04008140 for additional details. Contact HP
Response center if you face any issue with Ignite-UX version C.7.17.361.
The C.7.17.361 release of Ignite-UX supports the following HP-UX release or architecture
combinations:
Table 5 HP-UX Release/Architecture Combinations Supported on Ignite-UX Version C.7.17.361
HP Integrity systemsHP 9000 systemsHP 9000 systems
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
After downloading this version from the Web, you can install it on any server running on any one
of the HP-UX releases listed in Table 4.
Ignite-UX version C.7.17.361 includes the following new feature – Support SATA DVD.
For details about how to enable support for SATA DVD drives and related known issues, see
Ignite-UX Admin Guide available at www.hp.com/go/ignite-ux-docs.
This release also includes fixes for the following Change Requests:
• QXCR1001292737 – Ignite now addresses both the naming schemes efficiently across all
versions of VxVM.
• QXCR1001297350 – In Agile-only mode, during recovery ionit will not fail due to negative
instance numbers.
• QXCR1001301043 – Ignite now allows user to proceed with the installation from itool without
entering the networking information if the selected interface is configured as part of Auto Port
Aggregate.
• QXCR1001252115 – Changes to Ignite-UX to automatically cope with active lun changes
on ALUA arrays.
• QXCR1001247114 – Ignite cleans the system from any leftover stale legacy dsf (if any) in
the final phase of the recovery.
• QXCR1001269775 – Ignite now does the error handling more accurately for ctl class of
devices.
• QXCR1001266262 – make_tape_recovery changes to call “pax –A” with –E option. By
default “-A” will not be called.
• QXCR1001255889 – make_*_recovery commands will correctly report what is partially
included and what is completely included.
• QXCR1001262219 – Stale partition devices were removed in recovery.
Notes related to known problems with this release:
QXCR1001268159 – A device that does not support any SCSI level identity such as VPD pages
0x80 and 0x83 may not be recovered correctly.
Version C.7.16.283 (March 2013)
The C.7.16.283 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Version C.7.17.361 (October 2013 – This version is suspended and unsupported.) 11