Ignite-UX Release Notes HP-UX 11iv1, HP-UX 11iv2, and HP-UX 11iv3 (5900-3360, November 2013)

3 Ignite-UX releases
This section describes supported Ignite-UX releases. Major changes and defect fixes for each
release are described here.
Version C.7.17.391 (November 2013 - Web release only)
The C.7.17.391 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 4 HP-UX release/architecture combinations supported on Ignite-UX version C.7.17.391
HP Integrity systemsHP 9000 systemsHP 9000 systems
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
After downloading this version from the Web, you can install it on any server running on any one
of the HP-UX releases listed in Table 4.
Ignite-UX version C.7.17.391 includes the following new feature—Support SATA DVD. For details
about how to enable support for SATA DVD drives and related known issues, see Ignite-UX Admin
Guide available at www.hp.com/go/ignite-ux-docs.
This release also includes fixes for the following Change Requests:
• QXCR1000908613 – Ignite-UX now supports recovery of SATA devices.
• QXCR1001268768 – Booting 1303 ISO on a VM by mounting the image will prevent core
dump.
• QXCR1001292737 – Ignite-UX now addresses both the naming schemes efficiently across
all versions of VxVM.
• QXCR1001297350 – In Agile-only mode, during recovery ionit will not fail due to negative
instance numbers.
• QXCR1001301043 – Ignite-UX now allows user to proceed with the installation from itool
without entering the networking information if the selected interface is configured as part of
Auto Port Aggregate.
• QXCR1001252115 – Changes to Ignite-UX to automatically cope with active lun changes
on ALUA arrays.
• QXCR1001247114 – Ignite-UX cleans the system from any leftover stale legacy dsf (if any)
in the final phase of the recovery.
• QXCR1001269775 – Ignite-UX now does the error handling more accurately for ctl class of
devices.
• QXCR1001266262 – make_tape_recovery changes to call “pax –A” with –E option. By
default, “-A” will not be called.
• QXCR1001255889 – make_*_recovery commands will now correctly report the volume
groups which have been partially or completely included during archive creation.
• QXCR1001262219 – Stale partition DSFs were removed in recovery.
Notes related to known problems with this release:
QXCR1001268159 – A device that does not support any SCSI level identity such as VPD pages
0x80 and 0x83 may not be recovered correctly.
QXCR1001320837 - During restoration of archive, an error message occurs intermittently about
file /dev/srp being missing.
10 Ignite-UX releases