Ignite-UX release notes HP-UX 11iv1, HP-UX 11iv2 and HP-UX 11iv3 (5900-2307, April 2012)

• QXCR1001039432. The -i option of make_sys_image, which was applicable only for
B.11.00 and earlier releases, has been obsoleted.
• QXCR1001044588. HP Integrity BL860c i2 Server Blade systems support network boot when
incoming requests are relayed.
• QXCR1001045036. Warning messages for B.11.31 clients will be displayed if the selected
path is in either a standby or failed state.
• QXCR1001045660. On B.11.31,make_sys_image will not proceed with an archive creation
if legacy device support is disabled on the system. Please enable the legacy device support
using the 'insf -L' command and recreate the archive.
• QXCR1001048801. Ignite-UX has improved the logic to search for LIF or archive from a
Recovery tape for an Integrity system, to reduce the time required to restore the system.
• * QXCR1001052772. The script called by make_opticaldisc_recovery that looks for
a date specific filename is modified to closely match with the format of the filename instead
of the date itself.
• * QXCR1001055810. Ignite-UX has been updated to correctly display the maximum volume
group size in itool window.
• QXCR1001057724. When running make_net_recovery with the -r option to resume a
preview, it will now remove all the configuration directories associated with an old recovery
archive.
• QXCR1001058334. Recovery image installs of 11.31 clients with either compartments
enabled or configured as Secure Resource Partitions (SRP) are now supported.
• QXCR1001059542. Tape archive creation/recovery will succeed on a HP-UX B.11.23
IPF machine even if the /dev/rmt/stape_config file is missing. That file was used to
check the type of the tape which is not required and therefore that check has been removed.
• * QXCR1001073659 The save_config script will now correctly process the VxVM volumes
with 5.1 pre-enablement changes in Ignite-UX.
• QXCR1001075059. The VxVM components in the Ignite-UX install environment and the
installation depot must be version 5.0 or higher in order to use persistent DSFs.
• QXCR1001075174. Support has been added to permit swm-based installs over NFS for
B.11.31.
• QXCR1001075974. Ignite-UX will not allow the root volume to be configured under a FlexFC
VFC.
• QXCR1001075979. Ignite-UX will not allow swap/dump to be configured under a FlexFC
VFC.
• QXCR1001075980. itool now supports NPIV/FlexFC VFC configured on a system.
• QXCR1001092353. The fix for QXCR1000942141 has been backed out to support creation
of tape archives on multiple tapes for IPF systems.
• QXCR1001093531 Ignite-UX has been modified to detect and support physical memory of
size greater than 2TB(upto 8TB) during the cold installation and Network Recovery.
Notes related to known problems with this release:
There are no new known problems.
Version C.7.12.519 (3/2011) 15