Ignite-UX release notes HP-UX 11iv1, HP-UX 11iv2 and HP-UX 11iv3 (5900-2307, April 2012)

• QXCR1001102946. save_config can now handle any number of disks in a VxVM disk
group.
• QXCR1001108276. When make_*_recovery commands are run in preview mode and
then resumed, the manifest file is created in the correct directory.
• QXCR1001111254. list_expander doesn't walk through the autofs mount points anymore,
thus preventing them from getting mounted every time.
• QXCR1001111586. make_*_recovery will exit with an appropriate message in the
presence of Cluster-wide Device Special File (cDSF). make_*_recovery does not support
the creation of an archive with volume groups configured using cDSF as input.
• QXCR1001119119. make_net_recovery can now unmount the mounted client directory
after creating the network archive when the client has more than 30 LANs.
• QXCR1001120228. The 11.31 install kernel was updated with VxVM 5.0.1 patch
PHKL_42115 to enable recognition of SAS based disk drives on rx2800 models.
• QXCR1001121908. itool now accepts legacy hardware path even if it is longer than the
width of its text box in the 'More Info' window.
• QXCR1001124612. The autoboot status of a client is now gathered along with primary
hardware path information with a single invocation of the setboot command. This will aid
in not overwhelming the Onboard Administrator when multiple installs are going on
simultaneously with virtual partitions on Superdome 2.
• QXCR1001126779. When the configuration file is hand-edited and has no disk defined in
the root volume group, users will be allowed to correct that in the itool window.
Notes related to known problems with this release:
There are no new known problems.
The following limitation is applicable for the current release:
Starting with March 2011 update of HP-UX 11i v3, Ignite-UX version C.7.12 or above supports
installation of 5.1 SP1 software and configuration of the disks for use.
Though 5.1 VxVM creates disk group with a disk group version of 160 by default (outside Ignite-UX
Environment), Ignite-UX only supports the creation of disk group version 140 during the installation
using 5.1 VxVM software. VxVM disk groups with a disk group version of 160 cannot be restored
using Ignite-UX version C.7.12 or above.
Archive creation of those volumes having disk group version of 160 is not supported by Ignite-UX
and the archive creation process does not display any error/warning indicating that the restore
operation will fail.
Future versions of Ignite-UX may support archive/restore operations of VxVM disk groups with a
disk group version of 160 or above. For the latest information on the Ignite-UX product, refer to
the latest version of the Ignite-UX Release Notes.
Version C.7.12.519 (3/2011)
The C.7.12.519 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 8 HP-UX Release/Architecture Combinations Supported on Ignite-UX Version C.7.12.519
HP Integrity systemsHP 9000 systemsHP-UX release
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
Version C.7.12.519 (3/2011) 13