Ignite-UX release notes HP-UX 11iv1, HP-UX 11iv2 and HP-UX 11iv3 (5900-2307, April 2012)

• QXCR1001111979. Legacy DSFs for ciss-driver based HBAs are recovered properly with no
stale DSFs left around.
• QXCR1001129212. The bootable flags for the paths are appropriately set before the preferred
path is selected.
• QXCR1001130947. SAS disks are now recovered correctly even when multiple paths pointing
to the same disk are present in a different order from that of the archive.
• QXCR1001131156. The expected value of the final size of the LIF volume is now set to the
maximum value possible.
• QXCR1001135320. The APA interfaces are commented out from the /etc/rc.config.d/
netconf file during recovery.
• QXCR1001139466. Recovery of servers that use only aggregate lan interfaces has been
made more efficient.
• QXCR1001139486. Post recovery, Ignite-UX comments out entries of the
INTERFACE_MODULES variable at the same index as the other variables that make up a
definition of the IP address to apply to an interface in the netconf file.
• QXCR1001141025. The make_*_recovery command is changed to call list_expander
with the -m option, which allows archiving of files of size greater than 8GB.
• QXCR1001144550. Available free space in a file system is calculated using a 64-bit variant
of statvfs64 system call. This is for servers with greater than 2TB file systems to work as
expected.
• QXCR1001144624. The 'ignite client list' command correctly displays macaddress
information for all the client NICs.
• QXCR1001153339. Ignite-UX uses the new -B option of the setboot command to avoid
unnecessary generation of IPMI calls.
• QXCR1001154910. The print_manifest command is changed to display disk sizes
greater than 4TB.
• QXCR1001155333. Ignite-UX provides support to automatically detect the pax block size.
• QXCR1001164448. The list_expander command is updated to handle the symlinks
efficiently and to check what is to be included in the archive.
• QXCR1001166847. For VxVM, the name of the file system does not necessarily have to end
with 'vol'.
• QXCR1001173668. The make_*_recovery command is enabled to support archive and
recovery of systems in agile-DSF mode. This feature is currently limited to systems that do
not use sasd driver based disks.
Notes related to known problems with this release:
There are no new known problems.
Version C.7.13.259 (9/2011 - Web Release Only)
The C.7.13.259 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 6 HP-UX Release/Architecture Combinations Supported on Ignite-UX Version C.7.13.259
HP Integrity systemsHP 9000 systemsHP-UX release
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
Version C.7.13.259 (9/2011 - Web Release Only) 11