Ignite-UX release notes HP-UX 11iv1, HP-UX 11iv2 and HP-UX 11iv3 (5900-2307, April 2012)

3 Ignite-UX Releases
This section describes supported Ignite-UX releases. Major changes and defect fixes for each
release are described here.
Version C.7.14.274 (3/2012 - Web Release Only)
The C.7.14.274 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 4 HP-UX Release/Architecture Combinations Supported on Ignite-UX Version C.7.14.274
HP Integrity systemsHP 9000 systemsHP-UX release
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
After downloading from the Web, this version can be installed on any server running on any one
of the above HP-UX releases.
See “Version C.7.14.264 (3/2012)” (page 10) for information about the changes in this version
of Ignite-UX.
Version C.7.14.264 (3/2012)
The C.7.14.264 release of Ignite-UX supports the following HP-UX release/architecture combinations:
Table 5 HP-UX Release/Architecture Combinations Supported on Ignite-UX Version C.7.14.264
HP Integrity systemsHP 9000 systemsHP-UX release
NoYesB.11.11
YesYesB.11.23
YesYesB.11.31
After downloading from the Web, this version can be installed on any server running on any one
of the above HP-UX releases.
Ignite-UX version C.7.14.264 contains the following new feature:
The following manual page entries are either added or updated:
• ignite-client(1M)
• ignite-config(1M)
• ignite-ui(1M)
• ignite-version(1M)
• ignite(1M)
• instl_adm(4)
• make_net_recovery(1M)
Fixes for the following Change Requests:
• QXCR1001047654. While saving a configuration, if the physical volumes (PVs) belong to a
physical volume group (PVG), they are not listed under the volume group.
• QXCR1001065414. The instance numbers for legacy disk DSFs is recovered correctly by
Ignite-UX.
• QXCR1001099187. During tape recovery, APA starts only when networking is enabled.
10 Ignite-UX Releases