Ignite-UX (IUX) Frequently Asked Questions (July 2013)

archive do not end up on the client. Why?
8.3 Q: What do these errors mean: pax_iux: X: Cross-device link, pax_iux:
X: File exists, or pax_iux: X : Device busy?
9. Obtaining Ignite-UX
----------------------
9.1 Q: What is different about the Web version?
9.2 Q: Is Ignite-UX available on media?
9.3 Q: How do I update my Ignite-UX server to a new version?
9.4 Q: How much of Ignite-UX do I need to install?
9.5 Q: How can I copy Ignite-UX from media to a local depot such that
Ignite-UX from this new local depot will be installable on all
HP-UX B.11.* systems?
10. Loading Patches
-------------------
10.1 Q: How do I prevent backup copies of patched files from being saved?
10.2 Q: Why are patches left in an installed state when I install the
Support Plus patch bundle along with HP-UX 11.x from CD?
11. Network Recovery
--------------------
11.1 Q: How can I learn more about network recovery?
11.2 Q: How can I clone a client using make_net_recovery?
11.3 Q: How can I tell which files will be included in the archive
created by make_net_recovery?
11.4 Q: How can I tell which disks or volume groups get re-created
during an installation from a make_net_recovery configuration?
11.5 Q: How can I use make_net_recovery if I need to be able to recover
from a tape?
11.6 Q: Which files does Ignite-UX change during an installation from a
make_net_recovery configuration?
11.7 Q: How can I keep archives from being deleted by make_net_recovery
when new archives and configurations are created by subsequent
invocations of make_net_recovery?
11.8 Q: How can I make configuration file additions to all recovery
configurations for a given client?
11.9 Q: How can I select from the standard file system layouts during a
recovery?
11.10 Q: I replaced the client machine and the LAN address is now
different. How can I restore the new machine from the old
client network recovery archive?
11.11 Q: Dealing with hot swappable disks during recovery.
11.12 Q: Why does archive_impact fail during make_net_recovery?
11.13 Q: How can I restore VxVM DCO log volume groups?
11.14 Q: Are the layered/striped/mirrored VxVM volumes included in the
recovery archive when a client recovery archive is created?
11.15 Q: Can I run make_tape_recovery/make_recovery in single user mode? If
so, how?
11.16 Q: Why are there invalid disk device files left behind after some
recoveries?
11.17 Q: How can I install additional software from depots during a recovery?
11.18 Q: Why am I getting this message: Warning: untrusted X11 forwarding
setup failed?