Ignite-UX Installation Booting

14
Without going into detail about the new format for bootable tapes on HP Integrity servers, the tape
contains the following files (this assumes the recovery tape does not span multiple tapes):
Recovery Tape Contents
File Number Contents File Number Contents
1 ANSI Label containing VOL1
header
13 ANSI Label
2 EFIBOOTHPUX 14 IINSTALL
3 ANSI Label 15 ANSI Label
4 ANSI Label 16 ANSI Label
5 BOOTLOADER 17 IINSTALLFS
6 ANSI Label 18 ANSI Label
7 ANSI Label 19 ANSI Label
8 FPWSAEFI 20 HPUXIUXLIF
9 ANSI Label 21 ANSI Label
10 ANSI Label 22 ANSI Label describing
archive
11 AUTO 23 Archive
12 ANSI Label
When reading the above table, please note the numbering of the files going down the columns -
the files appear on the tape in the order of the file numbers given in the table.
Starting with Ignite-UX version C.7.7, the ansitape command is recommended for file access
instead of counting files.
To boot the tape, the EFI loadfile interface is used to load the file called “BOOTLOADER” from the
tape (it is found via the ANSI label introducing the file). This file contains an executable EFI
program; once loaded it is set running.