Ignite-UX Custom Configuration files

WINSTALLFS -12290 69408 35840 0 04/11/15 13:57:12
IINSTALL -12290 105248 197630 0 04/11/15 13:57:26
VINSTALL -12290 302880 73806 0 04/11/15 13:57:32
WINSTALL -12290 376688 83837 0 04/11/15 13:57:38
IINSTALLFS -12290 460528 116224 0 04/11/15 13:57:47
PAD BIN 576752 256 0 04/11/15 13:57:48
If you have customizations to apply to the installation file systems, you should apply them now
using instl_adm.
The instl_adm command , prior to Ignite-UX version C.6.0.x, will not update the Itanium®-
based installation file system IINSTALLFS if any PA-RISC installation file systems are present
(this issue is being addressed at this time; review the release notes for your version of Ignite-UX to
determine if it has been resolved). If you wish to apply custom configuration to the Itanium®-
based installation file system, you must perform the following commands:
# lifcp ./mylif:IINSTALLFS ./IINSTALLFS
# instl_adm -f output -F ./IINSTALLFS
# lifrm ./mylif:IINSTALLFS
# lifcp -r -T-12290 -K2 ./IINSTALLFS ./mylif:IINSTALLFS
This assumes that the configuration you wish to apply is located within the file called output
above.
Remember that these steps are not required if the LIF does not contain any of the PA-RISC
installation file systems (INSTALLFS, WINSTALLFS, or VINSTALLFS) or if you are using Ignite-
UX C.6.0.x or greater. So with Ignite-UX C.6.0.x and greater, all of the installation file systems
will be updated by instl_adm. If you wish to maintain different configurations in each file
system, you must manually modify the Itanium-based installation file system, IINSTALLFS as
previously described.
Tip:
If you only wish to support PA-RISC systems, you can write the LIF you
just created directly onto a
CD and use it to boot systems.
4. You must create a pseudo-root for our CD image; this is necessary to add support for Itanium®-
based systems. Enter the following commands:
# mkdir top
# mv my_lif top
# cp /opt/ignite/boot/EFI_CD_image top/EFI_CD_image
# cd top
5.
Create an ISO image that can be written to a CD. You may need to load additional software
from your applications media to get the mkisofs command onto your system.
# /opt/ignite/lbin/mkisofs -no-emul-boot -b EFI_CD_image \
-eltorito-alt-boot -no-emul-boot -b my_lif -o ../cdfs.out $(pwd)
Messages similar to the following appear:
209