Ignite-UX Custom Configuration files

/opt/ignite/boot/boot_lif). T
his new format is capable of showing you a menu-like
selection and asking you to choose a kernel to boot. Of course, to provide for non-interactive
installation and recovery, there is a time-out value for a response and a default response.
With PA-RISC systems using Ignite-UX version C.6.0.x or later, an HP-UX B.11.11 kernel is used to
install and recover HP-UX B.11.11 systems, and an HP-UX B.11.23 kernel is used to install and
recover HP-UX B.11.23 systems. You cannot install or recover HP-UX B.11.11 systems using the
HP-UX B.11.23 kernel, and the HP-UX B.11.11 kernel cannot install or recover an HP-UX B.11.23
system. There is only a 64-bit HP-UX B.11.23 PA-RISC kernel. Ignite-UX prevents you from
performing an unsupported installation using an incorrect kernel during installation.
Note the following:
 Currently, auto_adm only affects PA-RISC systems. There is only one Itanium®-based kernel
shipped with Ignite-UX; no method is required to select between it and another kernel.
 This command exists from Ignite-UX version C.6.0.x onwards.
 With Ignite-UX version C.6.0.x, the new auto_adm formats in the AUTO file provide an
enhancement to the current form of the AUTO file; they are not a replacement.
Looking at auto_adm
As stated in the auto_adm(1M) manpage, the following forms are allowed:
/opt/ignite/bin/auto_adm -n -T timeout -M message -l label -c command -b
device -i image [-o outfile] [-O output_format] [-?]
/opt/ignite/bin/auto_adm -a -l label -c command -b device -i image
[-f infile] [-o outfile] [-O output_format] [-?]
/opt/ignite/bin/auto_adm -A appendfile -f
infile [-o outfile]
[-O output_format] [-?]
/opt/ignite/bin/auto_adm -L
label record_modifier [-f infile]
[-o
outfile] [-O output_format] [-?]
/opt/ignite/bin/auto_adm -d -L
label [-f infile] [-o outfile]
[-O output_format] [-?]
/opt/ignite/bin/auto_adm -D -L
label [-f infile] [-o outfile]
[-O
output_format] [-?]
/opt/ignite/bin/auto_adm -T
timeout [-f infile] [-o outfile]
[-O output_format] [-?]
/opt/ignite/bin/auto_adm -M
message [-f infile] [-o outfile]
[-O
output_format] [-?]
ISL and CONF format data
CONF data
The auto_adm manpage does not correctly document all of the allowed combinations of options.
For instance, the preceding forms of the command do not allow the following example:
156