HP Storage Platform 2.1 Release Notes

[2013-Jan-29 11:04:26] Administrator attempted login, result: success.
HP 6G Virtual SAS Manager CLI 3.1.3.0 (Switch 5,VSM Active,OK)
Rescanning - this may take a few minutes...
Rescan complete
6. Once prompt is given, reset the SAS switch by executing the following command:
=> sw local reset hardware forced
[2013-Jan-29 11:06:39] Hardware reset on Switch 5, Scope: Local switch
only.
Performing hard reset
=>
7. Retry the operation (discovery/flash recommendation/flash) that has failed using FMT.
This is issue and procedure is documented in the troubleshooting section of the HPSP_FMT User Guide
published in SAW as document number c03598024. Please consult that reference for more details.
Presently, this document is not public but the next release of HPSP documents will publish this on
HP.COM. Until then, your HP service engineer can provide these details to you if needed.
• The HPSP credentials service uses SSH to communicate to the MSA array in the 9320 system. There is a
known issue with the SSH service that causes a problem. There are several ways to carry out a
recommendation of the FMT to perform firmware updates as shown in the following three examples:
o Use the credentials service for controller credentials:
hpsp_fmt –fr storage -cs
o Pass the controller credentials using command line arguments:
hpsp_fmt –fr storage –ci 10.20.12.122 –cu manage –cp \!manage
o Prompt for controller user credentials:
hpsp_fmt –fr storage –ci 10.20.12.122
Consult the HPSP_FMT User Guide published in SAW as document number c03598024-1 for more
details. Presently, this document is not public but the next release of HPSP documents will publish this on
HP.COM. Until then, your HP service engineer can provide these details to you if needed.
HPSP 2.1 Release Notes 16