6.0 HP X9720 Network Storage System Administrator Guide (AW549-96034, December 2011)

IMPORTANT: The /opt/hp/hp-snmp-agents/cma.conf file controls certain actions of the
SNMP agents. You can add a trapIf entry to the file to configure the IP address used by the
SNMP daemon when sending traps. For example, to send traps using the IP address of the eth1
interface, add the following:
trapIf eth1
Then restart the HP SNMP agents:
service hp-snmp-agents restart
For more information about the cma.conf file, see Section 3.1 of the Managing ProLiant servers
with Linux HOWTO at Managing ProLiant servers with Linux HOWTO .
Start or restart Insight Remote Support services
Start or restart the following services:
• System Management Homepage:
# service hpsmhd restart
• SNMP Agent:
# service snmpd restart
• HP SNMP Agents:
# service hp-snmp-agents start
To ensure that hp-snmp-agents restarts when the system is rebooted, enter the following
command:
# chkconfig hp-snmp-agents on
Discover nodes on HP SIM or IRSS
For X9000 systems, HP Systems Insight Manager (SIM) uses the SNMP protocol to discover and
identify systems automatically. If desired, you can configure HP SIM to discover system-specific
network segments, a targeted host, or IP address ranges. For IRSS, see the HP Insight Remote
Support Standard A.05.50 Hosting Device Configuration Guide for more information. (Use the
link in the “Prerequisites” section to locate this guide.) For HP SIM, see the HP System Insight
Manager 6.x User Guide at: http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/
c02537452/c02537452.pdf
Configure Entitlements
Configure the CMS software to enable remote support for X9000 systems.
Configuring HP Insight Remote Support on X9000 systems 23