5.6.x HP X9000 Series Network Storage System Installation Guide (TA768-96056, December 2011)

14. To complete the bond configuration, enter a space to select the Cluster Network role. Then
enter the IP address and netmask information that the network will use. The user network is a
VIF on bond1 for 10GbE network that in configured in X9000 Software.
Repeat this procedure to create a bonded user network (typically bond1) and any custom
networks as required.
15. When you complete your entries on the File Serving Node Configuration Menu, select Continue.
16. Verify your entries on the confirmation screen, and select Commit to apply the values to the
File Serving Node and register it with the management console.
17. After the server is registered, you are asked whether you want to configure a passive agile
management console on the node.
IMPORTANT: Configure a passive agile management console only if the following conditions
are met:
• The agile management console is enabled and an active agile management console is
configured.
• The passive agile management console is not configured on any other nodes in the cluster.
Configuring file serving nodes manually 31