HP StoreAll Storage Network Best Practices Guide
Table Of Contents
- HP StoreAll Storage Network Best Practices Guide
- Contents
- 1 Overview of HP StoreAll Storage networking
- 2 StoreAll 9730 platform networking
- 3 StoreAll 93xx/8x00 platform networking
- 4 Expanding an existing cluster
- 5 Support and other resources
- 6 Documentation feedback
- A BOND modes
- B StoreAll 93xx 10 GbE bonding modes and switch interconnection
- C Install and the default Virtual Connect configuration
Table 19 StoreAll 93xx/8x00 flat network configuration — cabling summary (continued)
DestinationOriginConnection
Customer Edge Switch – Management
subnet
Rear of MSA enclosure, Upper
controller slot, Integrated RJ-45
connector
MSA enclosure, Controller A (9320
only)
Customer Edge Switch – Management
subnet
Rear of MSA enclosure, Lower
controller slot, Integrated RJ-45
connector
MSA enclosure, Controller B (9320
only)
Verifying the network configuration
Run the following command to verify and troubleshoot the flat network configuration.
Verify node network interface devices. Use the ifconfig command to summarize the available
network interfaces, configured bond interfaces, and active VIFs.
NOTE: In a dual 10 Gb NIC configuration, slave eth 6 and slave eth 7 are present in ifconfig.
62 StoreAll 93xx/8x00 platform networking