HP StorageWorks ExDS9100c/X9720 Storage System Controller Cache Module (448023-003, December 2009)

Step 3: Installing the controller
1. Install the controller in the chassis:
a. Squeeze the thumb latch on the controller and rotate the latch
handle down.
b. Slide the controller all of the way into the chassis. The latch
handle will automatically rotate up and click when locked into
place.
To make sure that the controller is fully seated, lightly push up
on the latch handle and push the controller body into the
chassis.
IMPORTANT:
As you insert the controller in the enclosure, keep
it level until it is completely installed. If the
controller is tilted, it may catch a component on
the chassis edge and damage the controller.
2. Connect cables to the controller.
3. Power on the enclosure.
Verifying component status
• Verify that the controller LED on the rear of the chassis is green.
• Verify that no error messages are displayed on the seven-segment
display.
IMPORTANT:
See the netework storage system administration guide for
additional software or hardware instructions.
Returning the failed component
Follow instructions shipped with the replacement part.
Additional information
HP: http://www.hp.com
HP support: http://www.hp.com/support
Page 4