6.2 HP IBRIX 9000 Storage CLI Reference Guide (TA768-96070, December 2012)

file system goes into a MIF state again. If recovery succeeds, the file system’s state is set to OK
and it processes all outstanding logged file system changes and it will continue to update the
database of new changes.
Display the status of the Express Query system:
ibrix_archiving -i
Displays the status of the Express Query system. For example:
AJ Database Status : OK
AJ Scanner Status : OK
Command succeeded!
Start the set of Express Query Daemons:
ibrix_archiving -s
Stop the archiving system:
ibrix_archiving -S [-F] [-t timeout secs]
Stops the set of Express Query daemons.
The -t option specifies the time (in seconds) to wait for the Express Query daemons to stop
gracefully.
The -F option forcefully stops the daemons and disables database access to all file systems enabled
for Express Query.
NOTE: The database is stored on the file system, and it is closed before the file system is
unmounted. Because closing the database can take a long time, the -F option can be used to
forcefully stop the archiving daemons and disable database access to all file systems enabled for
Express Query. When you restart the archiving system after using the -F option, the database
enters in recovery mode, which can take a long time to complete depending on the size of the
database.
Restart the archiving system:
ibrix_archiving -r
Stops and immediately restarts the set of Express Query daemons.
Change the timeout period for the archiving component watchdog:
ibrix_archiving -w [timeout]
Changes the timeout period for the Express Query watchdog. The default timeout is 30 seconds.
The watchdog periodically checks the health of the daemon processes and restarts them if necessary.
Options
DescriptionOption
Clears Manual intervention Failure State.—C
Forcefully stops the Express Query daemons.-F
Stops the Express Query daemons.-S
Displays the status of the Express Query system.-i
Lists file systems registered to Express Query.-l
Restarts the Express Query daemons.-r
Starts the Express Query daemons.-s
Sets the time (in seconds) to wait for Express Query to stop gracefully.-t timeout secs
10 IBRIX software commands