5.6.x HP X9000 Series Network Storage System Installation Guide (TA768-96056, December 2011)

MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 100
Down Delay (ms): 0
Slave Interface: eth1
MII Status: up
Link Failure Count: 0
Permanent HW addr: 78:e7:d1:64:3a:1c
Slave Interface: eth2
MII Status: up
Link Failure Count: 0
Permanent HW addr: 78:e7:d1:64:3a:19
View the configuration
You can check the IP, netmask and broadcast configuration with the ifconfig command. When
run on the sample configuration shown in the previous step, the display appears as follows (bond0
and lo are omitted in output):
# ifconfig
bond1 Link encap:Ethernet HWaddr 78:7E:D1:64:3A:1C
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1
RX packets:7224794 errors:0 dropped:0 overruns:0 frame:0
TX packets:3286647 errors:1 dropped:0 overruns:1 carrier:0
collisions:0 txqueuelen:0
eth1 Link encap:Ethernet HWaddr 78:E7:D1:64:3A:1C
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3573025 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643167 errors:1 dropped:0 overruns:1 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x1080
eth2 Link encap:Ethernet HWaddr 78:E7:D1:64:3A:19
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3651769 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643480 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9 Base address:0x1400
Configure system parameters
Change passwords
Change passwords for the Onboard Administrator, iLO, Virtual Connect and SAS switch. This can
be deferred until the configuration work is complete, or left for the customer to make the changes.
Configure DNS settings
Create or modify the /etc/resolv.conf file and add entries to configure the addresses of
domain name servers, as required. For example:
nameserver 10.10.155.1
nameserver 192.168.2.254
search <domain-prefix> # e.g., hp.com for the HP domain
Run nlslookup to test the configuration:
nslookup
>server
38 Installing and configuring X9720 systems