5.6.x HP X9000 Series Network Storage System Installation Guide (TA768-96056, December 2011)

5. The Verify Configuration window shows the configuration received from the management
console. Select Accept to apply the configuration to the server and register the server with the
management console.
NOTE: If you select Reject, the wizard exits and the shell prompt is displayed. You can restart
the wizard by entering the command
/usr/local/ibrix/autocfg/bin/menu_ss_wizard or logging in to the server again.
6. After the server is registered, you are asked whether you want to configure a passive agile
management console on the node.
IMPORTANT: Configure a passive agile management console only if the following conditions
are met:
• The agile management console is enabled and an active agile management console is
configured.
• The passive agile management console is not configured on any other nodes in the cluster.
If you have configured a user network, enter a VIF IP address and netmask.
Using the template to configure file serving nodes 23