5.6.x HP X9000 Series Network Storage System Installation Guide (TA768-96056, December 2011)

Creating a template for configuring file serving nodes
To simplify configuring your file serving nodes, you can create a template to apply to each node.
The template specifies the IP address that the nodes will use to access the management console,
defines how hostnames will be generated for the nodes, and specifies a range of IP addresses to
be used when configuring networks on the nodes. You can also change some of the parameters
specified with the Management Console Configuration Wizard if necessary.
You can create the template on the Cluster Configuration menu, which starts automatically after
you confirm the management console configuration. Exit the menu if you do not want to use the
template.
1. The Introduction describes how the template is used.
2. The Cluster Configuration Menu operates in the same manner as the Management Console
Configuration Menu.
Creating a template for configuring file serving nodes 15