5.6.2 HP IBRIX X9000 Release Notes

1. Identify the segment residing on the physical volume to be removed. Select Storage from the
Navigator on the management console GUI. Note the file system and segment number on the
affected physical volume.
2. Locate other segments on the file system that can accommodate the data being evacuated from
the affected segment. Select the file system on the management console GUI and then select
Segments from the lower Navigator. If segments with adequate space are not available, add
segments to the file system.
3. If quotas are enabled on the file system, disable them:
ibrix_fs -q -D -f FSNAME
4. Evacuate the segment. Select the file system on the management console GUI and then select
Tasks > Rebalancer from the lower Navigator. Click Start on the Task Summary page to open the
Start Rebalancing dialog, and then open the Advanced tab. In the Source Segments column,
select the segments to evacuate, and in the Destination Segments column, select the segments to
receive the data. (If you do not select destination segments, the data is spread among the available
segments.) Then click Evacuate source segments. The Task Summary window displays the progress
of the rebalance operation and reports any errors. If you need to stop the operation, click Stop.
5. When the rebalance operation completes, remove the storage from the cluster:
ibrix_fs -B -f FSNAME -n BADSEGNUMLIST
The segment number associated with the storage is not reused.
6. If quotas were disabled on the file system, unmount the file system and then re-enable quotas
using the following command:
ibrix_fs -q -E -f FSNAME
Then remount the file system.
Spare parts information
The following spare part is now available for X9320 systems:
Part number 605475-001 — Drive (DRV) HD 2TB 6G 7.2K 3.5 SAS P2000
In general, the spare parts lists in the X9300, X9320, and X9720 administrator guides are current as
of the publication dates of the documents. For the latest spare parts information, go to http://
partsurfer.com.
For future use
Although the following features are available on the Management Console GUI or CLI, they are
intended for future use and are not currently supported.
• X9000 snapshots on HP P4000 storage systems
• The Cloning and Async Cloning options listed in the GUI Navigator under Filesystems > Tasks
Installation instructions
New installations
HP X9000 File Serving Software is preinstalled on supported devices. If you need to reinstall the
software, see the administration guide for your storage system.
Upgrades
The upgrade procedure is provided in the administration guide for your storage system. Contact HP
Support for assistance with the procedure.
IMPORTANT: If you are upgrading to the 5.6.1 release from an X9000 Software version earlier
than 5.5, first upgrade to the latest 5.5 release, and then upgrade to 5.6.1.
20 For future use