HP Reference Information Storage System v1.6 Administrator Guide (T3559-96073, July 2007)

3. If the d atabase server was reinstalled, run one of the following commands to restore the
/db2/VolBack partition from either the version stored on the kickstart server or tape backups.
NOTE:
This will delete the content of the VolBack directory.
/opt/bin/backup/db2BackupUtility -restore_from_kickstart
/opt/bin/backup/db2BackupUtility -restore_from_tape
4. To restore the database, make sure the database is up by issuing the command:
su db2udb –c db2start
5. To restore DB2, run the following command. It will ask for a timestamp of a backup to restore.
Normally, the last two backups of the database are kept.
/opt/bin/backup/db2BackupUtility -restore_db2
6. After the installation is nished, run /opt/bin/start on the PCC server to start the RIS S system
and validate that it o perates correctly.
Restoring the master conguration les
Copies of the master conguration les are kept in the /usr/local/MasterConfigFiles
directory on the PCC server. Whenever one of the les is changed on the kickstart server and
the converter is run, the master conguration le is copied to the PCC server, and renamed to
YYYY-MM-DD-hh.mm.ss_FileName. It is a lso backed up to tape, if application backup is enabled.
To restore this directory from the tape backup, run the following command on the PCC server:
/usr/local/tsmBackup/rotateMasterConfigBackup –restore
72
Data management