HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

6–1HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
6
Using CLI for Configuration
This chapter presents an example of how to configure a storage subsystem using the
Command Line Interpreter (CLI). The CLI configuration example shown assumes:
• A normal, new controller pair, which includes:
— NODE ID set
— No previous failover mode
— No previous topology set
• Full array with no expansion cabinet
• PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 6–1. The example system contains
three non-clustered VMS hosts, as shown in Figure 6–2. From the hosts’ point of
view, each host will have four paths to its own virtual disks. The resulting virtual
system, from the host’s point of view, is shown in Figure 6–3.