HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

FC Configuration Procedures
5–19HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
5–19
For example:
The commands to create Stripe1, a stripeset consisting of three disks (DISK10000,
DISK20000, and DISK10100) and having a chunksize of 128:
ADD STRIPESET STRIPE1 DISK10000 DISK20000 DISK30000
INITIALIZE STRIPE1 CHUNKSIZE=128
SHOW STRIPE1
Configuring a Mirrorset
1. Create the mirrorset by adding its name to the controller's list of storagesets and
by specifying the disk drives it contains. Optionally, you can append mirrorset
switch values:
ADD MIRRORSET MIRRORSET-NAME DISKNNNNN DISKNNNNN SWITCHES
NOTE: See the ADD MIRRORSET command in the StorageWorks HSG80 Array Controller
ACS Version 8.7 CLI Reference Guide for a description of the mirrorset switches.
2. Initialize the mirrorset, specifying any desired switches:
INITIALIZE MIRRORSET-NAME SWITCHES
See “Specifying Initialization Switches” on page 2–29 for a description of the
initialization switches.
3. Verify the mirrorset configuration:
SHOW MIRRORSET-NAME
4. Assign the mirrorset a unit number to make it accessible by the hosts. See
“Assigning Unit Numbers and Unit Qualifiers” on page 5–23.
For example:
The commands to create Mirr1, a mirrorset with two members (DISK10000 and
DISK20000), and to initialize it using default switch settings:
ADD MIRRORSET MIRR1 DISK10000 DISK20000
INITIALIZE MIRR1
SHOW MIRR1