HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

FC Configuration Procedures
5–18 HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
• “Configuring a Single-Disk Unit (JBOD)” on page 5–21
• “Configuring a Partition” on page 5–21
Figure 5–4: Storage container types
Configuring a Stripeset
1. Create the stripeset by adding its name to the controller's list of storagesets and by
specifying the disk drives it contains. Use the following syntax:
ADD STRIPESET STRIPESET-NAME DISKNNNNN DISKNNNNN.......
2. Initialize the stripeset, specifying any desired switches:
INITIALIZE STRIPESET-NAME SWITCHES
See “Specifying Initialization Switches” on page 2–29 for a description of the
initialization switches.
3. Verify the stripeset configuration:
SHOW STRIPESET-NAME
4. Assign the stripeset a unit number to make it accessible by the hosts. See
“Assigning Unit Numbers and Unit Qualifiers” on page 5–23.
Partition
Striped mirrorset
(R0+1)
Stripeset
(R0)
RAIDset
(R3/5)
Mirrorset
(R1)
Single
devices
(JBOD)
Storagesets
Containers
CXO6677A