HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

FC Configuration Procedures
5–13HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
5–13
6. Assign an identifier for the communication LUN (also called the command
console LUN, or CCL). The CCL must have a unique identifier that is a decimal
number in the range 1 to 32767, and which is different from the identifiers of all
units. Use the following syntax:
SET THIS IDENTIFIER=N
Identifier must be unique among all the controllers attached to the fabric within
the specified allocation class.
7. Set the topology for the controller. If both ports are used, set topology for both
ports:
SET THIS PORT_1_TOPOLOGY=FABRIC
SET THIS PORT_2_TOPOLOGY=FABRIC
If the controller is not factory-new, it may have another topology set, in which
case these commands will result in an error message. If this happens, first take
both ports offline, then reset the topology:
SET THIS PORT_1_TOPOLOGY=OFFLINE
SET THIS PORT_2_TOPOLOGY=OFFLINE
SET THIS PORT_1_TOPOLOGY=FABRIC
SET THIS PORT_2_TOPOLOGY=FABRIC
8. Set Allocation class to a decimal number between 0 and 999. The number must be
unique across the fabric. Set allocation class using the following syntax:
SET THIS ALLOCATION_CLASS=N
Restart the Controller
9. Restart the controller, using the following command:
RESTART THIS
It takes about a minute for the CLI prompt to come back after a RESTART command.
Set Time and Verify All Commands
10. Set the time on the controller by entering the following syntax:
SET THIS TIME=DD-MMM-YYYY:HH:MM:SS
11. Use the FRUTIL utility to set up the battery discharge timer. Enter the following
command to start FRUTIL:
RUN FRUTIL