HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

Installing and Configuring HSG Agent
4–9HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
4–9
Table 4–3: Information Needed to Configure Agent
Term/Procedure Description
Adding a Client system
entry
For a client system to receive updates from the
Agent, you must add it to the Agent’s list of client
system entries. The Agent will only send
information to client system entries that are on
this list. In addition, adding a client system entry
allows you to access the Agent system from the
Navigation Tree on that Client system.
Adding a subsystem entry You need to tell the Agent the subsystem that it
needs to monitor.
Client system Network names for the computers on which the
Client software runs.
Client system access
options
The access privilege level controls the Client
system’s level of access to the subsystems.
0=No Access−Can use the Client software to add
a system to a Navigation Tree, set up a pager,
and view properties of the controller and the
system. You cannot use Client to open a Storage
Window.
1=Show Level Access−Can use the Client
software to open a Storage Window, but you
cannot make modifications in that window.
2=Storage Subsystem Configuration
Capability−Can use the Client software to make
changes in a Storage Window to modify a
subsystem configuration.