HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and Configuration Guide

Installing and Configuring HSG Agent
4–7HSG80 ACS Solution Software Version 8.7 for Compaq OpenVMS Installation and
Configuration Guide
4–7
9. If you have an OpenVMS cluster running the MultiNet TCP/IP stack, the
command procedure SWCC_CONFIG.COM will only upgrade the services of
each system disk’s first node. Enter the following to upgrade the services database
of the other nodes that share the system disk:
$ @MULTINET:INSTALL_DATABASES
or
Restart the system.
10. Dismount the CD-ROM. Enter the following at the command prompt and then
press Enter (The following example assumes that your CD-ROM drive is
DKB600.):
$ DISMOUNT DKB600:
11. Run the configuration program. Enter the following at the command prompt:
$ @SYS$MANAGER:SWCC_CONFIG
If the installation does not detect any configuration files from a previous
installation, you are shown a configuration script when you run the configuration
program. During the configuration, you will need to do at least the following:
— Enter the name of the client system on which you installed the Client
software. You can enter more than one client system. For a client system to
receive updates from the Agent, it must be on the Agent’s list of client system
entries. In addition, adding a client system entry allows you to access the
agent system from the Navigation Tree.
NOTE: Enter your most important client system first and the client system that is infrequently
connected to the network last. The software will put the client system entry that you entered first
to the top of its list of client systems to be contacted.
— Enter client system notification options and the client system access options.
— Enter the name for a subsystem and the device name used to access the
subsystem. You can enter more than one subsystem. If you want to monitor
and manage a subsystem, you need to enter this information. The subsystem,
which is comprised of the controller and its array of physical devices, must
have access to the Agent system.
— Enter a password. It must be a text string that has 4 to 16 characters. It is
entered from the client system to gain configuration access.
— Start the Agent. The Agent runs as a process in the background. When you
start the Agent, you are instructing the software to start monitoring the
subsystems.