HSG60 and HSG80 Controller and HSx80 Cache Module Replacement Procedures for Array Controller Software V8.7x-x Release Notes

Replacing HSx80 Cache Modules in Single and Dual-Redundant Controller Configurations
44 HP StorageWorks HSG60 and HSG80 Controller and HSx80 Cache Module Replacement
Procedures for Array Controller Software V8.7x-x Release Notes
 6. For the cache module to be replaced, note the location for each DIMM in the
cache module that was replaced, and install the DIMMs in the corresponding
locations in the replacement cache module. Use the following substeps to
remove the DIMMs:
Note: The DIMMs must be removed for installation in the replacement cache module.
 a. Press down on the DIMM retaining clips (see Figure 17 on page 38) at
both ends of the DIMM being removed.
 b. Gently remove the DIMM from the DIMM slot, and place the DIMM on
an antistatic bag or a grounded antistatic mat.
 c. Repeat substep 6a and substep 6b above for each DIMM.
 7. Enter N(o) to the question for a replacement cache module.
FRUTIL exits.