HSG60 and HSG80 Controller and HSx80 Cache Module Replacement Procedures for Array Controller Software V8.7x-x Release Notes

Replacing HSG60 and HSG80 Controllers in Single and Dual-Redundant Controller Configurations
26 HP StorageWorks HSG60 and HSG80 Controller and HSx80 Cache Module Replacement
Procedures for Array Controller Software V8.7x-x Release Notes
Installing an HSG60 or HSG80 Controller in Dual-Redundant Controller
Configurations
Perform the following steps to install a controller in a dual-redundant controller
configuration if only the controller is not installed. If both controller and
associated cache module are not installed, proceed to “Installing an HSx80 Cache
Module in Dual-Redundant Controller Configurations” on page 45” first, and then
return to this section to install the controller.
Caution: Be sure that the controller being installed has the same ACS version
as the operational and previous controller. Failure to follow this precaution will
cause controller configuration information to be erased, and the controller will
be rendered unusable.
H 1. Determine whether you will be installing the replacement controller (H) in
an ACS V8.7, V8.7-1, V8.7-2, or V8.7-3 environment, and then complete one
of the following options:
H ■ Go to step 2 and proceed if you are installing the replacement controller in
an ACS V8.7-3.
H ■ Go to step 4 (on page 28) and proceed if you are installing the
replacement controller in an ACS V8.7, V8.7-1, or V8.7-2 environment.
H 2. Complete one of the following options:
H ■ Proceed to step 4 (on page 28) if you have the ACS V8.7-3 patch-on-card
PCMCIA card.
H ■ Complete the following substeps, and then proceed to the next step, if you
do not have the ACS V8.7-3 patch-on-card PCMCIA card:
H a. Use an offline subsystem to manually install the ACS V8.7-2 and
V8.7-3 patches to the replacement controller.
H b. Connect a PC or terminal to the replacement controller.
H c. Insert the replacement controller in the subsystem without the
program card.
H d. Press and hold the Reset button.
H e. Insert the ACS V8.7-1 program card while pressing the Reset button.