HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes
256 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
0E170101 An invalid sense key was detected during WHL processing.
Last Failure Parameter [0] contains unexpected sense key.
01
0E180100 Call to VA$ENABLE_NOTIFICATION( ) failed due to
INSUFFICIENT_RESOURCES.
01
0E199001 “This controller” comes up misconfigured to avoid a recursive bug check.
Issue the SET NOFAILOVER CLI command on the “other controller,”
and then issue a “SET MULTI COPY=THIS” from the “other
controller.”
Note: Note that there is a unit that is inoperative. Take corrective steps
to resolve that unit.
90
12000103
12010103
Two values found not equal:
Last failure parameter [0] contains the ASSUME instance address.
Last failure parameter [1] contains the first variable value.
Last failure parameter [2] contains the second variable value.
Changes to equal.
01
12020103
12030103
12040103
12050103
First value found greater or equal:
Last failure parameter [0] contains the ASSUME instance address.
Last failure parameter [1] contains the first variable value.
Last failure parameter [2] contains the second variable value.
Changes to greater.
Changes to smaller or equal.
Changes to smaller.
01
12060102 VSI_PTR->NO_INTERLOCK not set:
Last failure parameter [0] contains the ASSUME instance address.
Last failure parameter [1] contains NV_INDEX value.
01
12070102 VSI_PTR->ALLOCATED_THIS not set:
Last failure parameter [0] contains the ASSUME instance address.
Last failure parameter [1] contains NV_INDEX value.
01
Table 56: Last Failure Codes and Repair Action Codes (Sheet 43 of 55)
Last
Failure
Code
Description
Repair
Action
Code