HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes

214 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide

Hardware and software flag

The hardware and software (HW) flag is located at byte offset 104, bit 7. If this

flag is a 1, the unrecoverable condition is due to a hardware detected fault. If this

flag is a 0, the unrecoverable condition is due to an inconsistency with the

software, or a requested restart or shutdown of the controller.

Repair Action Code

The Repair Action Code at byte offset 105 indicates the recommended Repair

Action Code assigned to the failure. This value is used during symptom-directed

diagnosis procedures to determine what notification and recovery action to take.

For details about recommended Repair Action Codes, see Table 49 on page 167.

Error Number

The Error Number is located at byte offset 106. Combining this number with the

Component ID field value uniquely identifies the reported failure.

Component ID Code

The Component ID Code is located at byte offset 107. This code uniquely

identifies the software component that reported the failure. For details about

component ID codes, see the “ASC, ASCQ, Repair Action, and Component

Identifier Codes’ chapter that starts on page 161.

Last Failure and Repair Action Codes

Table 56 lists Last Failure Codes that are issued from the controller. Codes are

listed in ascending order.

Table 56: Last Failure Codes and Repair Action Codes (Sheet 1 of 55)

Last

Failure

Code

Description

Repair

Action

Code

01000100 Memory allocation failure during executive initialization. 01

01010100 An interrupt without any handler was triggered. 01

01020100 Entry on timer queue was not of type Associated Queue (AQ) or

Blocking Queue (BQ).