HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Instance Codes
203HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
03F10502 The swap interrupt from the device port, indicated by
the Associated Port field, cannot be cleared. All swap
interrupts from all ports are disabled until corrective
action is taken. If swap interrupts are disabled, neither
controller front panel button presses nor removal or
insertion of devices are detected by the controller. In
this instance, the Associated Target, Associated ASC,
and Associated ASCQ fields are undefined.
41 05
03F20064 Swap interrupts are cleared and re-enabled for all
device ports. In this instance, the associated port,
Associated Target, Associated ASC, and Associated
ASCQ fields are undefined.
41 00
03F30064 An asynchronous swap interrupt was detected by the
controller for the device port, indicated by the
Associated Port field. Possible reasons for this
occurrence include:
■ Device insertion or removal.
■ Shelf power failure.
■ Swap interrupts re-enabled.
In this instance, the Associated Target, Associated
ASC, and Associated ASCQ fields are undefined.
41 00
03F40064 Device services had to reset the port to clear a bad
condition. In this instance, the Associated Target,
Associated ASC, and Associated ASCQ fields are
undefined.
41 00
03F60402 The controller shelf is reporting a problem. This
condition could mean one or all of the following:
■ If the shelf uses dual power supplies, one power
supply failed.
■ One of the shelf cooling fans failed.
■ In this instance, the Associated Target, Associated
ASC, and Associated ASCQ fields are undefined.
41 04
Table 53: Instance Codes and Repair Action Codes (Sheet 23 of 30)
Instance
Code
Description Template
Repair
Action
Code