User Manual - A3661-90001

Unsolicited Event Log 6-53
Troubleshooting
0x3E Media error remap failed An attempt to do a remap after a Media error failed for some
reason other than one of the following: another media error, a
timeout, cannot remap (no LBA provided), or bad defect list.
All of these errors are itemized separately.
0x3F Media error bad defect list Device returned a Media Error check condition which
specifically indicates that the device’s “defect list” is no good
(03/19) or (03/1c). A remap is not possible for these errors.
0x7E Extended media error A remap of a bad block failed. Usually seen with event codes
0x820 or 0x920.
0x80 CRU Powered Down During a sniff, the device was found to be powered down.
0x81 CRU Powered Up Dead While powering up a CRU died.
0x82 CRU Defined Powered
Down
Switched from defined state to powered down
0x83 CRU Defined Dead Drive found dead while in defined state.
0x84 CRU Too Small Drive is too small to fit in the assigned LUN.
0x85 CRU Unsupported Drive is not supported and has been shutdown.
0x86 CRU Format Failed The format of the drive aborted for some reason. Further
information may be provided in other Unsolicited Event Log
messages.
0x87 CRU Idle Powered Down CRU was found to have powered down while idle.
0x88 CRU Idle Dead CRU died while in idle state.
0x89 CRU Bind Powered Down The drive powered down while unbound.
0x8A CRU Bind Dead CRU died while unbound.
0x8B CRU Wait for Assign
Powered Down
CRU powered down while in the RDY state.
0x8C Shutdown Shutdown while waiting to assign a LUN. Usually seen with
event code 0xA07. CRU died in RDY state.
0x8D CRU Rebuild Powered
Down
CRU powered down during a rebuild.
0x8E CRU Rebuild Dead CRU died during a rebuild.
0x8F CRU Enabled Powered
Down
CRU powered down in ENA state.
0x90 CRU Enabled Dead CRU died in ENA state.
Table 6-12 Extended Status Codes (Continued)
Extended
status code
Extended status code
name Description