User Manual - A3661-90001

6-52 Unsolicited Event Log
0x28 Spindle synchronization
change
This error code should never be seen.
0x29 Not ready/start in progress This error code should never be seen.
0x2A Transfer count not zero Too few bytes were transferred by a drive during an I/O
operation.
0x2B Bad interrupt An unexpected or incorrect interrupt was received from a
SCSI protocol chip or drive.
0x2C Too much data Too many bytes were sent or requested by a drive during an
I/O operation.
0x2D Bad bus phase A drive violated the SCSI bus protocol.
0x2E Bad message A drive violated the SCSI bus protocol.
0x2F Bad reselection A drive violated the SCSI bus protocol.
0x30 Parity error A SCSI bus parity error was detected.
0x31 Message parity error A SCSI bus parity error was detected.
0x32 Status parity error A SCSI bus parity error was detected.
0x33 Bad status A drive violated the SCSI bus protocol.
0x34 Invalid CDB An invalid command was issued. This error code should never
be seen.
0x35 Unsupported function This error code should never be seen.
0x36 No device driver This error code should never be seen.
0x37 Unsupported IOCTL option This error code should never be seen.
0x38 Unexpected disconnect A drive violated the SCSI bus protocol.
0x39 User reset The device was reset. This can be caused by a previous error.
0x3A Protocol time-out A drive violated the SCSI bus protocol.
0x3B Recovered error cannot
remap
The device reported a Recovered error that required ECC to
recover the data (01/18), but it did not report the bad LBA in
the sense data. The SP microcode was unable to attempt a
remap.
0x3C Recovered error remap
failed
An attempt to do a remap after a Recovered error failed for
some reason other than one of the following: another media
error, a timeout, cannot remap (no LBA provided), or bad
defect list. All of these errors are itemized separately.
0x3D Media error cannot remap The device reported a Media error (03/xx) but it did not report
the bad LBA, remap was not enabled.
Table 6-12 Extended Status Codes (Continued)
Extended
status code
Extended status code
name Description