User Manual - A3661-90001

Unsolicited Event Log 6-51
Troubleshooting
0x10 Unit attention The drive reported an unexpected unit attention with
unrecognized sense data. This code should never be seen.
0x11 Device aborted command The disk did not complete a command issued by SP
microcode.
0x12 Bus reset occurred Similar to 0x0E, except FRU had a command active at the
time of reset.
0x13 Verify error A read after a write did not verify what was written.
0x14 to 0x18 Logical sector data error
(checksum error)
The SP microcode has detected a logical data error on a
sector(s) of data.
0x19 No sense data Drive had a problem with a request sense operation.
0x1A Device too small A disk with insufficient capacity has been introduced in a
bound LUN.
0x1B Bus shut down Indicates the SP microcode has shut down the SCSI bus
disabling any activity or its ability to interrupt.
0x1C Unexpected Sense Key The targeted disk returned a Sense Key unknown to SP
microcode.
0x1D Unknown SCSI bus error The SCSI bus has reported an unrecognizable error.
0x1E Diagnostic miscompare During the execution of power-up diagnostic, test data is
written and read to all disks. This indicates a data miscompare
on one of the drives.
0x1F Write stamp error SP microcode information imbedded in the data stored on the
array was inconsistent with what was expected.
0x20 Device dead The targeted disk is not available. Any residual commands to
that disk initiate this code.
0x21 Recovered error The targeted disk returned “Recovered Error” Sense Key,
excluding invoking ECC and spindle sync.
0x22 Recovered error with ECC The targeted disk returned “Recovered Error, ECC invoked”
SCSI Sense Key.
0x23 No error Sense Key The targeted drive returned “No Error” SCSI Sense Key.
0x24 Logical sector data error Same as 0x14 to 0x18.
0x25 Host driver abort Host caused termination of back-end bus activity.
0x26 Host bus protocol error An unrecoverable protocol error on the host bus caused an
I/O to terminate.
0x27 Host bus parity error The host bus parity error retry count was exceeded for an
I/O, causing it to terminate.
Table 6-12 Extended Status Codes (Continued)
Extended
status code
Extended status code
name Description