User Manual - A3661-90001

6-50 Unsolicited Event Log
GLVFRYHUVWKDWWKHGLVNPRGXOHLQVORW$LVSRZHUHGGRZQ'LVNPRGXOH$LVRZQHGE\63$7KH
8QVROLFLWHG(YHQW/RJIRU63$FRQWDLQVWKH[$HUURUZLWKDQH[WHQGHGVWDWXVRI[&58
(QDEOHG'HDG63%UHSRUWVWKH[$HUURUZLWKDQH[WHQGHGVWDWXVRI[&583RZHUHG'RZQ
Table 6-12 Extended Status Codes
Extended
status code
Extended status code
name Description
0x00 None No error information available.
0x01 SCSI protocol error An error was detected and retried during activity on an internal
SCSI bus between the SP and the disk itself.
0x02 Device detected parity error Drive returned sense data indicating data sourced at the SCSI
interface device on the SP encountered an internal parity
error.
0x03 Device busy Drive returned a “SCSI Busy” status indicating more than one
request was sent to the disk before the first one completed.
This can be seen most frequently in dual initiator (host)
configurations.
0x04 Improper SCSI status byte An unrecognized status byte was received during a SCSI
transfer, possibly due to a SCSI protocol violation.
0x05 Media error A hard media error was detected at the disk level and the
sector remapped.
0x06 Time-out error The SP microcode allocates 10 seconds for a disk to complete
a command. This error is a result of a disk not completing a
command within the allocated response time.
0x07 Selection time-out The targeted drive did not respond to SCSI selection. A status
of 0x47 indicates retries failed.
0x08 Not ready The drive returned a “Not Ready” SCSI Sense Key.
0x09 Hardware error The drive returned “Hardware Error” Sense Key. Indicates an
internal electro-mechanical problem on the disk module.
0x0A Bad format Indicates the drive format has changed from the expected
sector standard for the array.
0x0B Wrong device The drive is reporting a type not supported.
0x0C User abort This error code should never be seen.
0x0D Illegal request The drive returned an “Illegal Request” Sense Key. This
indicates an illegal command was sent to the disk.
0x0E Device saw bus reset The drive reported a Unit Attention resulting from the SP
microcode issuing a SCSI Bus Reset. The drive was idle at
time of reset or was just inserted.
0x0F Mode select occurred This error code should never be seen.