User Manual - A3661-90001

Unsolicited Event Log 6-39
Troubleshooting
Table 6-8 Informational Codes
Event code Event code name Description
0x601 SP Power Up The SP is powered up and ready for I/O. This field also shows
the revision of microcode (Licensed Internal Code) and the
amount of SP memory in MB, in hexadecimal. For example,
(SP Powerup); Rev 0x00080A01 0x00000020 means code
revision 8.10.01 and 32 MB of memory.
0x602 Drive Enabled The unit this drive belongs to is ready for normal host I/O.
0x603 Rebuild Started The background rebuild process has begun rebuilding the
data on this drive.
0x604 Rebuild Completed The background rebuild process has completed rebuilding the
data on this drive.
0x606 Unit Shutdown for
Trespass
The unit of which this drive is a member has been shut down
by this SP at the request of the peer SP, due to a Trespass
operation.
0x607 Unit Shutdown for
Change Bind
The LUN this module belongs to has been shut down by this
SP in order to change its operating parameters. This
shutdown is needed only when the SP is operating in Target
Addressing Mode.
0x608 Drive Ready The specified drive is powered up and physically ready for
use.
0x609 Format Started The given FRU is being formatted.
0x610 Format Failed The format started on the disk module was unsuccessful so
the disk can not be used by the SP. Make sure the disk
module is a valid model. If it is valid, consult your Hewlett-
Packard support representative for recovery service.
0x611 SP PROM Rev Notes PROM revision, the extended status identifies the SP’s
ID. This message is logged once at the completion of every
powerup.
0x613 CRU Equalize Started The SP has started a Rebuild/Equalize operation.
0x614 CRU Equalize Completed The SP has completed a Rebuild/Equalize operation.
0x615 CRU Equalize Aborted The SP has aborted a Rebuild/Equalize operation.
0x616 Flare Installed Extended status identifies revision information. This message
is logged once when new flare code is installed.
0x617 Code Installed to Drive Extended status identifies revision information. This message
is logged, once for each updated drive, when new drive code
is installed. Note that the revision information for drives
consists of 4 ASCII characters (for example, code “0123” will
appear as 0x30313233).