User Guide

8QVROLFLWH G (YHQW/RJ 8-31
Troubleshooting
7DEOH ,QIRUPDWLRQDO&RGHV
Event code Description
0x601 SP Power Up. The SP is powered up and ready for I/O. This field also shows the
revision of microcode (Licensed Internal Code) and the amount of SP memory in
Mbytes, in hexadecimal. For example,
(SP Powerup); Rev 0x00080A01 0x00000020
means code revision 8.10.01 and 32 Mbytes of memory.
0x602 Drive Enabled. The unit this drive belongs to is ready for normal host I/O.
0x603 Rebuild Started. The background rebuild process has begun rebuilding the data
on this drive.
0x604 Rebuild Completed. The background rebuild process has completed rebuilding
the data on this drive.
0x606 Unit Shutdown for Trespass. The unit of which this drive is a member has been
shut down by this SP at the request of the peer SP, due to a Trespass operation.
0x607 Unit Shutdown for Change Bind. The LUN this module belongs to has been shut
down by this SP in order to change its operating parameters. This shutdown is
needed only when the SP is operating in Target Addressing Mode.
0x608 Drive Ready. Specified drive is powered up and physically ready for use.
0x609 Format Started. The given FRU is being formatted.
0x610 Format Failed. Disk module could not be physically formatted, and thus cannot
be used in the disk array. Make sure the disk module is a valid model. If the
model is valid, consult your HP service representative for recovery service.
0x611 SP PROM Rev. Notes PROM revision, extended status is this SP’s SCSI ID.
This message is logged once at the completion of every powerup.
0x613 CRU Equalize Started. The SP has started a Rebuild/Equalize operation.
0x614 CRU Equalize Completed. The SP has completed a Rebuild/Equalize operation.
0x615 CRU Equalize Aborted. The SP has aborted a Rebuild/Equalize operation.
0x616 Flare Installed. Extended status is revision information. This message is logged
once when new flare code is installed.
0x617 Code Installed to Drive. Extended status is revision information. This message is
logged, once for each updated drive, when new drive code is installed. Note that
the revision information for drives consists of 4 ASCII characters (for example,
code “0123” will appear as 0x30313233).
0x621 Background Verify Started. A background check on the correctness of parity
information has begun on the unit of which this drive is a member.