OS SNMP Support Manual (620-000131-620, April 2005)

E-26

E/OS SNMP Support Manual

MIB II

Description The destination IP address of this route. An entry with a value of

0.0.0.0 is considered a default route. Multiple routes to a single

destination can appear in the table, but access to such multiple entries

is dependent on the table-access mechanisms defined by the network

management protocol in use.

Sequence

::= { ipRouteEntry 1 }

ipRouteIfIndex

Syntax INTEGER

Access read-write

Status mandatory

Description The index value which uniquely identifies the local interface through

which the next hop of this route should be reached. The interface

identified by a particular value of this index is the same interface as

identified by the same value of ifIndex.

Sequence

::= { ipRouteEntry 2 }

ipRouteMetric1

Syntax INTEGER

Access read-write

Status mandatory

Description The primary routing metric for this route. The semantics of this

metric are determined by the routing-protocol specified in the route's

ipRouteProto value. If this metric is not used, its value should be set

to -1.

Sequence

::= { ipRouteEntry 3 }

ipRouteMetric2

Syntax INTEGER

Access read-write

Status mandatory

Description An alternate routing metric for this route. The semantics of this

metric are determined by the routing-protocol specified in the route's