FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
240 CLI Reference Guide for Directors and Edge Switches
Error 234: Invalid
Command
The CLI cannot associate
an action with the
submitted command. The
command may be
misspelled, required
parameters may be
missing, or the request
may not be applicable to
the branch of the CLI tree
from which it was
submitted.
Refer to Chapter 2 for the
correct command syntax
and spelling. Ensure that
the command is spelled
correctly and that all
required parameters are
included with the
command.
Refer to Navigation of the
CLI Command Tree on
page 25. Ensure that the
command has been
entered at the right place
in the CLI command tree,
and then resubmit the
command.
Error 235: Unrecognized
Command
The CLI does not
recognize the submitted
command and cannot
perform the help (?)
command as requested.
Refer to Using the
Command Line Interface
Help on page 33 for
information about the
help command.
Refer to Chapter 2 for the
correct spelling of the
submitted command.
Ensure that the command
is spelled correctly.
Refer to Navigation of the
CLI Command Tree on
page 25. Ensure that the
command has been
entered at the right place
in the CLI command tree,
and then resubmit the
command.
Error 236: Ambiguous
Command
The CLI does not
recognize the submitted
command issued.
The CLI cannot interpret
the command because a
unique match cannot be
identified. For the
appropriate syntax, see
the section of the manual
that corresponds to the
attempted command.
Enter the complete
command and resubmit.
Table 5: CLI Error Messages (Continued)
Message Description Action