High Availability Monitors Version A.03.02 Release Notes

NOF API Verbs (REGISTER_INDICATION_SINK to UNREGISTER_INDICATION_SINK)
REGISTER_INDICATION_SINK
Chapter 5994
Returned Parameters: Successful Execution
If the verb executes successfully, SNAplus2 returns the following
parameters:
primary_rc AP_OK
secondary_rc Not used.
Returned Parameters: Parameter Check
If the verb does not execute because of a parameter error, SNAplus2
returns the following parameters:
primary_rc AP_PARAMETER_CHECK
secondary_rc Possible values are:
AP_INVALID_OP_CODE
One of the following has occurred:
• The indication_opcode parameter did not match
the opcode of any of the SNAplus2 NOF API
indications.
• The indication_opcode parameter specified an
indication type that does not apply to the specified
target. If the target handle identifies the domain
configuration file, only configuration indications are
valid; if the target handle identifies the sna.net
file,onlySNA network file indications are valid; and
if the target handle specifies a running node, all
indications except SNA network file indications are
valid.
AP_DYNAMIC_LOAD_ALREADY_REGD
The indication_opcode parameter was set to a
reserved value.
AP_SYNC_NOT_ALLOWED
The application issued
REGISTER_INDICATION_SINK using the
synchronous NOF entry point. This verb must use the
asynchronous entry point.
Appendix A, “Common Return Codes,” lists further secondary return