High Availability Monitors Version A.03.02 Release Notes

NOF API Verbs (ACTIVATE_SESSION to OPEN_FILE)
DEFINE_LS
Chapter 3276
contact_timer
Timeout required before a SNRM or XID is
retransmitted in the event of nonacknowledgment
(used for primary SDLC only). This value must be
greater than the no response (T1) timeout value
no_resp_timer described below. The timer is specified
in milliseconds.
This timer is also used for special pre-activation
polling.
contact_timer_retry
Number of times transmission and retransmission of a
contact frame (such as SNRM) is allowed using the
normal poll timer before SNAplus2 changes to the slow
poll timer.
A value of 0xFFFF indicates an unlimited retry count.A
value of 0x0001 indicates that the switch to the slow
poll should be made after the first timer expiry.
contact_timer2
Slow poll contact timer in milliseconds. When the
contact timer retry count expires, SNAplus2 continues
to poll using this timer. This prevents leased
(multi-drop) links from being flooded by poll frames for
absent stations.
contact_timer_retry2
The slow poll contact timer retry limit value
corresponds to the number of times transmission and
retransmission of a contact frame (such as SNRM) is
allowed on the slow cycle before an outage message is
sent to the DLC user.
A value of 0xFFFF indicates an unlimited retry count.A
value of 0x0001 indicates that an outage should be
generated after the first slow poll timer expiry.
disc_timer
Timeout required before a DISC is retransmitted in the
event of nonacknowledgment (used for primary SDLC
only). The timer is specified in milliseconds.