High Availability Monitors Version A.03.01 Release Notes

Chapter 1 7

Required Patches and Known Problems

Required Software Patches

• The following patches (or their supersedents) are required. You must

install these patches before you install HA Monitors.

— PHKL_16751 (HP-UX 10.20) (981023)

Cumulative patch for SCSI/SIG_IGN/SIGCLD/LVM, JFS, PCI.

(Supersedes PHKL_16388, PHKL_16410)

— PHKL_13044 (HP-UX 10.20) (981023)

SCSI pass-through driver cumulative patch. Needed if you use the

disk monitor to monitor disks on an NIO bus. For HP-UX s800.

See Software Requirements, below, for directions for conﬁguring

the SCSI pass-thru driver, spt0, into the kernel.

— PHSS_17944 (HP-UX 10.20) OR

— PHSS_17945 (HP-UX 11.0)

OV EMANANTE14x consolidated patch. This patch upgrades the

SNMP master agent to send events using SNMP traps, and it

includes a Native Agent Adapter (naaagt) that Oracle SNMP

depends on.. After you install this patch, you need to set the

following in the /etc/SnmpAgent.d/snmpd.conf ﬁle:

get-community-name: public

If you choose a different community name, you must open each

/etc/opt/resmon/dictionary/mibmond.dict and

/etc/opt/resmon/dictionary/rdbmsmond.dict ﬁle. Add this

option to the end of each MONITOR directive:

-c

<community_name>

Refer to the man page for each monitor for more information.

— PHSS_17199 (HP-UX 11.0) (990218)

Fibre channel mass storage driver patch. For HP-UX s700 and

s800. (Supersedes PHSS_17108.) Please refer to Software

Requirements, below for more information about ﬁbre channel.

— PHSS_16209 (HP-UX 11.0) (980828)