Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 2-41
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
7. Rename each connection by typing the following command and pressing Enter:
rename !newconxx xxxxxxxxx
NOTE: You may use a maximum of nine alphanumeric characters.
Example: rename !NEWCONXX CLU2NODE1
8. Type the following command and press Enter:
set unit name disable_access_path=ALL
NOTE: The ALL access must be removed and set to NONE before adding the connection
names defined earlier.
9. Set the unit offset on each connection by typing the following command and
pressing Enter:
set xxxxxxxx unit_offset=100
10. Type the following and press Enter:
show connections
11. Verify the names and unit offsets assigned previously.
When step 10 has been completed, return to Table 2-10 of this chapter and continue
with the instructions for “Establishing a Redundant Path for the Microsoft Cluster” in
Chapter 4 of this guide.
Assigning Connection Paths for the Redundant Path of the Second Cluster
IMPORTANT: If connections are not defined, all new connections (the automatically
generated “!NEWCONxx” connections) will be assigned Unit Offset 0. This will result in all
boxes seeing all drives, minus units that have been reserved by the other cluster. (The unit will
be offline in Disk Administrator.)
NOTE: Only the connections in the cluster using port 2 of each controller need to be renamed.
The cluster using port 1 of each controller does not require renaming.
1. Power off all servers connected to the disk array.
2. Power on Server 1 in Cluster 2. (This server should have ALPA 4.)