Compaq ProLiant Cluster HA/F500 Administrator Guide

Secure Path Installation Procedures
4-20 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: e-ch4
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:52 PM
2. Follow the procedures in the “Configuring a Storageset” section in Chapter 2 to
configure a new storageset unit.
3. Use the CLI window to assign a preferred path to the new unit.
4. Use appropriate procedures to add a new volume to the server or cluster.
5. Restart both host servers so that Windows NT or Windows 2000 and the
Secure Path software can configure the new unit.
Refer to the Microsoft Cluster Server Administrator Guide to include new volumes in
the cluster.
Removing a Storageset with Secure Path
To remove a storageset:
1. Use Windows Disk Administrator to delete the partition from the drive to be
removed, using appropriate procedures.
2. Shut down the operating system on both host servers.
3. Use SWCC to delete the storagesets on the storage subsystem.
4. Restart both host servers to allow the Secure Path software to configure storage
devices.
Setting Up a Single Cluster with an Additional Storage Subsystem
(Dual Controller Configuration, Multibus Failover) with Hubs
To set up a single cluster with an additional storage subsystem:
1. Set up the cluster with the first storage subsystem according to the instructions in
Chapters 2 and 4 of this guide.